LockState LS-52EN Large Digital Wall Safe

LockState LS-52EN Large Digital Wall Safe Review

LockState LS-52EN Large Digital Wall Safe Feature

• Electronic digital lock
• Easily retrofits in any standard wall
• External dimensions: 20.67-Inch 13.78-Inch by 3.74-Inch
• Internal dimensions: 20.28-Inch by 13.39-Inch by 3.35-Inch
• Removable shelves

This home wall safe has a extra thin lock. The flush wall safe door is flat enough to put a picture in front of it. This hidden wall safe design gives you more interior room with wider shelves. This wall safe for sale has a digital electronic lock with a reprogramable combination. .63 cubic feet of storage. With dual live bolts. Installation of wall safe between the studs Use a Drill, Tape measure, pencil, framing square, socket set, stud finder, hole saw Scroll saw or saber saw, utility knife, level, wood shims, and flashlight. .1) unpack all electronic wall safes components from the carton. This wall safe contains keys and screws. .2) choose a location that is convenient for you, such as bedroom or closet avoiding exterior walls. .3) using a stud finder locate the approximate position of the right hand stud. Use your hole saw to drill a pilot hole to determine where the inside edge of this stud is located. Look inside this hole before cutting with a flashlight to check for electric, telephone and cable TV wires, heating ducts, or plumbing. It is important to avoid all such obstructions to prevent damage to your home during installation Using your square draw a line 21-1/8 inches along the inside edge of the stud. This is where you will install the hinge side of the electronic wall safe. Then using your square draw a line 14 inches to left from them top of your scribed line. Then repeat this on the bottom. Then draw a connecting vertical line. You should now have a rectangle 21-1/8 high by 14 inches wide .4) Starting at the pilot hole cut the sheet rock out with your saber saw. Then have a helper hold the home wall safes in position while you circle the bolt holes with a pencil on the studs before you let go of the hotel wall safes. Then drill the bolt pilot holes. Then socket wrench the bolts in on the right side of the in wall fire safes. Do not over tighten. Repeat on left side with shims if needed. Next install the shelves in the home wall safe.